Rainforest Eagle Manual de usuario descargar pdf (Pagina 2)

EAGLE™

Quick Start

For complete documentation, go to:

2 http://www.rainforestautomation.com/eagle_support

Rainforest EAGLE™ Information Label

(found on the underside of the device)

Setup

Step 1: Prerequisite software and hardware

1) A free Ethernet port on a router directly connected to the Internet.

2) A PC or other device with a web browser.

Step 2: Register your EAGLE™

Your EAGLE™ must be registered with your utility to connect to the smart meter. You will need

to contact your utility with two numbers (MAC Address and Install Code) that can be found on the

Information Label.

Note that it may take some time for your utility to enable the smart meter to connect with your

device. You must wait until this process is complete before proceeding; your EAGLE™ will not

function correctly until the smart meter is enabled.

Step 3: Power up your EAGLE™

1) Plug the Ethernet cable into a port on your router, and the other end into the Ethernet port on

your EAGLE™.

2) Plug the AC adapter into a nearby wall outlet, and plug the other end into the power socket

on your EAGLE™.

3) Allow two minutes for the device to boot up. You should see that 3 of the 4 status LED lights

(not the Cloud) are all on continuously. This indicates that the unit is functioning normally.

Install Code

MAC Address

Local Web

Address

Cloud

1 2 3 4 5

Sin comentarios

Rainforest Eagle Manual de usuario Pagina 2